Dino X-Ray

Print at 100% infill with a layer height of 0.2mm with a base layer of 0.32mm

Use any colors you'd like, either via AMS or by manually swapping filaments as indicated below.

Filaments Used:

PLA BambuLab Matte Charcoal Transmission Distance: 0.8

PLA SPARKLE BambuLab Slate Gray Sparkle Transmission Distance: 3

PLA BambuLab Matte Ash Gray Transmission Distance: 10

PLA BambuLab Basic Jade White Transmission Distance: 3

Swap Instructions:

Start with Charcoal

At layer #3 (0.72mm) swap to Slate Gray Sparkle

At layer #5 (1.12mm) swap to Ash Gray

At layer #8 (1.72mm) swap to Jade White for the rest.

Happy printing!