Philips Sonicare toothbrush charger plank attachment

In my bathroom I only have one outlet, and I like to charge my Philips Sonicare toothbrush in the bathroom. The cord of the charger is too short to let the charger sit on the plank below the outlet, and the low weight of the charger and toothbrush make it susceptible to falling off the plank above the outlet.

So, to solve this, I created a holder for the toothbrush charger so it sits now firmly attached to the plank.

Because my plank is probably not your plank, I've included the Fusion 360 archive file to allow you to tinker this to your own needs.

Print Settings

Printer:

BIQU B1

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

20%

Filament: eSUN PLA+ Cool white

Notes:

White filament looks the best. Print this oriented so you don't need supports.

If you unsure about the measurements you took, I recommend starting the print, and aborting it as soon as a part of the holder is printed. Then you can check, fit, modify the model, and print the final model.

Category: Bathroom