Dewalt DW735 Post Cap

A replacement cap for the posts on a Dewalt DW735 thickness planer. There are two versions:

• One is a close replica of the original part with a domed top. This one will require support in the center section.

• The other is slightly different than the original but prints without support. This one has a single layer bridge supporting the screw hole that can easily be cleared by drilled out or simply pushing the screw through. (Single layer bridge assumes a 0.2 layer height)

  Print Settings

Resolution:

0.2

Notes:

For the replica version you will need support in the center.
For the easy print version there is a single layer bridge inside the screw hole that you'll need to remove or push the screw thorough.