Geekvape Wenax S3 Cover in TPU - Vase Mode

A simple cover for the Wenax S3 , unfortunately the holes are not pre-cut since it has to be printed in vase mode with Overture High Speed TPU - Translucent Red.

Print as slow as you can. Use 0.94mm extrusion width for the external perimeter.

How to cut the holes:

1. remove the pod from the vape pen;
2. slide the cover on;
3. trace the holes with a marker;
4. remove the cover;
5. warm up and allen key on your gas stove or with a lighter (WARNING: hold the allen key with a insulating material or you will get burned);
6. use the allen key while still hot to melt through the cover (as shown in the picture);
7. clean up the holes with a hobby knife.