Dodecahedron Lamp

Print in any filament. Uses this LED light string.

Assembly Instructions:

1. Print the parts.
   1. 12x PentagonFrame
   2. 1x PentaTop
   3. 1x PentaBase
   4. 10x PentaFace
2. To assemble the bottom frame:
   1. Glue the PentagonFrame parts together. Use any glue that works with your filament.
3. To assemble the top
   1. Connect the PentaTop piece to the PentaBase piece by the central cylinder. Make sure that the points of one are centered over the edges of the other. Glue them together.
   2. Feed the LED strip through the slot in the bottom of the PentaBase part. Remove the adhesive cover and wrap the LED strip around the central cylinder in a spiral pattern. Wrap it tightly to make sure the full strip is used.
   3. Glue the PentaFace pieces to the PentaFace and PentaBase pieces to form the top of the lamp.
   4. Glue the top of the lamp to the bottom of the lamp.