Neopixel Jewel Burning Man Pendant

Burning Man pendant for my niece, the idea is to breath some color into it with a Adafruit neopixel jewel and a trinket. There's a space for the neopixel jewel to set, along with ample space for trinket & lipo battery: Check here for the code I started with: https://learn.adafruit.com/10-minute-neopixel-necklace/introduction

It is a work in progress. For now I'll probably use velcro to hold the guts in, but may make something more permanent in the future. There were a few mesh errors, so I ran the .stl through meshmixer and uploaded that as "Neopixel Jewel Burning Man Pendant-fixed.stl" - use this one if you have problems.

-Added photo of results using Prusa's ColorPrint, using glow PLA for the main body and silver for the top

Video: https://youtu.be/xRj2uyxRQ-s

Print Settings

Printer Brand:

Prusa

Printer: 

Prusa MK3S

Rafts:

Doesn't Matter

Supports: 

Yes

Resolution:

.2mm

Infill: 

20%

Notes:

I printed using supports at .2mm layer height until 13.64mm's, and then switched over to .1mm layer height for the rest of the print- this was to increase the quality of the emblem on the top. It will be fine if you just use the .2mm layer height for the entire print.

Material: Hatchbox PLA

Bed: 60

Nozzle: 225

How I Designed This

I fumbled my way through tinkercad to design this: https://www.tinkercad.com/things/h2RzVScw1Rv

I mixed in the emblem on top from this great tinkercad project: https://www.tinkercad.com/things/cipqIEOGN7u-burning-man-pendant

Category: Coins & Badges