Canopy for OMP M4 RC helicopter

This is a conopy that I designed for the OMP M4 RC helicopter.  I wanted some bright colors that really stand out so I decided to create a canopy in Fusion360 for it.  It is designed to use the same rubber canopy grommets that come with the M4.

It is best to print it nose up and using ‘Tree’ supports in Cura.  I also add 2 more rectangle shaped supports in front and behind to give it a little more support while printing as seen in the Cura preview picture.  I also enable brim to help a little more.

I use 0.2 layer height with ‘Use Adaptive Layers Maximum Variation' set to 0.05 and 'Adaptive Layers Variation Step Size' set to 0.025.  This allows curves to look better with a variation of layer height from 0.15 to 0.25 and still not slow the print down too much.