Instax Square Magnetic Frame

Magnetic frame for fuji instax Square photos.  No supports are needed.  Print with backside flat against the bed. To insert a photo, bend it slightly so it catches the notches, then push it flat.  See post it note in photo for reference. To remove, I use a flat metal spatula to lift it out.  

Prints FAST.  27g of filament, 49 minutes on mk4 using speed .2 with cubic infill.  

This is designed to accept four 6x2mm magnets, press fit in back.  You can also use 6x3mm magnets, which will slightly protrude. 

This is a quick print that uses little filament, creating a durable photo frame.  Prints great on mk4 with input shaping enabled.