Voron Galileo mount Sidewinder x1

I had to modify the mount of alliprice for the Galileo extruder - the pancake motor was too THICC.

So I had to adjust the parts and make them THICC too.

In the comparison you see the white one resembles the old, shorter design.

Jokes Aside, my printer runs reliable on this. I myself needed to make a little PCB (capacitor and diode to normalize the pulse) to get PWM (Speed Control) for the Fan working. The PCB mount part is adjusted now, I would be thankful of somebody could check if the spacing is enough to get the plugs into the Artillery PCB without bending.

As you can see its quite leaning forward, a thinner solution should be possible to mitigate that.

Still, this works for me, feel free to iterate. Open Source Roulz.

It would be SUPER helpfull if another person could post a make of this, I just want to know if this works for you.

Thanks and peace out