Raspberry Pi 5 & Pimoroni NVME Base Housing by Nerdiy.de

This is my nice looking 3D printable housing for the Raspberry Pi 5 and the Pimoroni NVME Base PCB.

Features:

• Precise fit for my Raspberry Pi 5 and the Pimoroni NVME Base PCB.
• Efficient ventilation for optimal heat dissipation.

Material required for the Raspberry Pi 5 and the Pimoroni NVME Base PCB:
To build the case for the Raspberry Pi 5 and the Pimoroni NVME Base PCB, you will need the following accessories:

• Raspberry Pi 5 4GB
  • Of course you also need a Raspberry Pi 5 for the case :)
• Pimoroni NVME Base
  • The NVMe module to boot from an SSD.
• Raspberry Pi 5 power supply
  • A reliable power supply for a stable power supply of the Raspberry Pi 5.
• Micro SD card 64GB
  • Store the operating system and data on a reliable micro SD card.
• M2 threaded insert
  • For the screw connection of the housing.
• M2x20 countersunk head screw 
  • Use these screws to securely fasten the Raspberry Pi and the NVMe module in the housing.

Note: 
The links above are Amazon-affiliate links and are intended as examples of the material required. Be sure to select the correct specifications and sizes.

Print settings:

• 0,2mm layerthickness
• 20% infill
• no support needed