Simple Lattice iCE40-HX8K Case

A little case for the Lattice Semiconductor iCE40 UltraPlus Breakout Board. Check the list below for compatible boards.

The board should sit quite firmly in the case itself and is held down by additional screws.

Recommended Material & Print Settings

• Nearly every Material should work, Test prints were done in PLA.
• No supports needed.
• Two (or more) perimeters recommended for the screw pegs to be solid enough

Additional Hardware

• 4x M3x10 DIN 912 Cylinder Screws (between 8 and 10mm should be fine)
• 4x M3 Heat Set Inserts (CNC Kitchen ones tested, others may work as well)

Compatible Boards

• Lattice iCE40HX8K-B-EVN
• Possibly others?

Please consider liking the model and posting a Make :)