BlueRetro Ps1 / Ps2 USB C

You will need the following items for this print:

• ESP32 30pin USB-C Dev board, these are common on places like aliexpress
  • https://www.aliexpress.com/item/1005006336964908.html

• Ps2 Controller Male Connector, i recommend the straight connector type or you need to bend the legs straight, these can also be found on aliexpress
  • https://www.aliexpress.com/item/1005005883733323.html

• 4x M2 bolts (M2*12 seems like the perfect length) and 4x M2 Nuts

Follow the wiring diagram for soldering made by “madmon” on thingiverse.

According to madmon you do not need to connect PIN3 to VIN.

The external sync LED is not needed as the onboard LED's on the dev board will be used, print the insert in transparent filament to let the light from the LED's shine trough.

I recommend printing the insert in PETG or other heat resistant filament as it will be directly touching the ESP32.

To flash the dev board follow darthcloud's guide on Github https://github.com/darthcloud/BlueRetro

Follow point 1. on the wiki for this build.

https://github.com/darthcloud/BlueRetro/wiki

I have printed and assembled several of these now and so far all of them have worked flawlessly.

I am a novice at 3d modeling and editing, if you have any questions feel free to leave a comment.

Edited the space for the port hole in the bottom to accommodate the USB C port and edited the buttons because the original buttons would collide with the USB C port.

Included are also taller and flatter buttons than the original design since i prefer them to be more pronounced and I prefer the feel of the flat buttons.