Customizable Canon EF mount

This is a printer friendly customizable Canon EF mount design with a f3d file.

On its own there is no practical use case for the part, but possible modifications could be:

• adding threads to the inside or outside to mount your camera to a lens/telescope
• making adapters to fit other lenses
• making a body cap

Printing Instructions:

• Make sure to orient the connecting bits up when printing.
• After printing during the first mounting some plastic will be shaved off and might not allow for the pin to click in on the first try. If this is the case twist off the mount, remove and plastic shavings and try again until it clicks into place