Combination & Speed Square Wall Mounted Holder

Wall mounted holder for three speed squares and four combination squares.   There are two versions and I have only printed V2 file.

V1 - Holders three speed squares and four combination squares.   The width is setup around a 7" Milwaukee speed square which was the widest square I had.  Most speed squares should fit it may just be a bit wider than necessary.   The model has also been updated to be a bit thinner than the original design but it is still probably overkill and could use some massaging to reduce the amount of filament used.

V2 - This was the original design I made for my specific application to allow this to hold a 12" speed square that extends past the end of the wall I have this mounted to.   Note that the slots are setup for 12" empire square, 7" Milwaukee speed square, and a 4-1/2" Milwaukee speed square in this application.