Light Stand PSU \ battery bank Mount (PARAMETRIC)

YOUTUBE VIDEO ABOUT THIS PROJECT:

HOW TO USE:

Measure your power brick following this diagram:

Bad_Diameter= the maximum width of the light stand you want to tie this to.

Open FIle into Fusio360 → change parameters → input the values you have previously measured → export STL → print

The slots are designed to work with 30mm double-sided Hook and Loop bands. And they can be adjusted in Sketch #3.

You can find cheap and colorful bands here: https://s.click.aliexpress.com/e/_DeUZSpR

If you plan to leave this attached to your power bricks I see no reason why you wouldn't use some zip-ties as well🤷

I printed this vertically using PLA-ST from eSUN and it holds well enough. Be careful some of these PSUs might get hot during use and can deform/ melt PLS so maybe print in better plastic if needed

If this model and my work improved the quality if your life you can show your appreciation by leaving me a tip here: https://www.paypal.me/vmphotoart

EDIT: I already added 2 more slots to tie it better to the light stand