Plant Stand - Simple Mid-Century Modern Planter Holder - Easy Print - Multiple Sizes

v2 Update Notes:

• I have slightly re-designed this model for improved structural stability. 
• Featured in this update are slightly thicker legs, a thicker platform, and a reinforced section between the legs to minimize flex and increase the weight capacity. 
• Sizing is the same across all models. 
• Although the visual changes are minimal, if you prefer the look of v1, the old files are still available in the “v1 Files” folder. 

Plant Stand - Simple Mid-Century Modern Planter Holder - Easy Print

Preface:

This is a simple, easy-to-print plant stand that channels mid-century modern themes. When printed with the right settings, these plant stands are very sturdy and should hold even very heavy plants. Featuring a chamfered platform edge and three legs that seamlessly blend into each other, this plant stand will fit in with any decor style.

There are a total of nine model files, each with a different height/platform size combination. The first number refers to the platform width, and the second number refers to the overall stand height. For example: "Plant Stand 001 7.5W 6H" is 7.5in wide and 6in tall.

Printing: 

These models print upside down, so I recommend using a textured buildplate if possible. This is not necessary, but will make the result look better in my opinion. I recommend the following settings:

• 4 walls
• 30% infill
• 0.2mm layer height

Note: I have found these settings to produce very sturdy results, but if you have an especially heavy plant that you're planning on using this for, I'd recommend increasing to 5-6 walls and 40% infill just for good measure. 

Other notes:

• The picture prints were completed using Elegoo Matte PLA. 
• This model is not for commercial use. If you are interested in selling your 3D prints of my models, please refer to my Printables Club!
• If you like this design, consider leaving a tip! I'm a university student, so anything helps!
  • https://www.paypal.me/theprintedplanter