Pi Zero No-IR Cam Clamp

A simple clamp to attach a "No-IR" camera module to a Raspberry Pi Zero (or Zero W).

The screws can either be screwed in directly or you can use M2.5x5 inserts to get a longer lasting thread.

You will need to print two of these clamps for one setup.

The print time should be below one hour.

Print Settings

Printer Brand:

Ultimaker

Printer:

Ultimaker 3

Rafts:

No

Supports:

Yes

Resolution:

0.1

Notes:

I used tree support as it is usually easier to remove. Be aware of not printing support within the screw holes, it will be very hard to remove. A Brim is also recommended.