(Un)original Prusa Drybox Stabilizer

About

This is an update to the (Un)original Prusa Drybox to keep it stable on the top of the Prusa enclosure. By default I think its perhaps a little to close to the edges for my taste so I designed some stabilizers to prevent the box from being knocked off accidentally. 

It maintains the ability to remove the drybox if needed, I'm using taller feet but the original shorter feet should work well also. 

Printing tips

Supports are not needed, I have integrated support material in the model.

It was designed for 0.2mm layer height with a 0.4 nozzle. You might be able to use a 0.6mm but I haven't tested it. 

This is a new model to allow the drybox to remain stationary whilst allowing the drybox to be removed easily if needed.