Instant Camera Picture Frames - Instax Mini, Square, and Wide

Update Feb 24, 2024: Updated frames so picture would be more centered vertically.

Update Feb 23, 2024: Updated frames to increase clearance for better fitment of photos.

No supports!

The mini, square, and wide frames were designed for the instax film listed here.

There are three sizes of film according to this site:

• Mini (86mm x 54mm)
• Square (86mm x 72mm)
• Wide (86mm x 108mm)

There should be a frame and a corresponding stand for that frame size. The tolerance to get the frame to slip into the stand is 0.15mm on each side (0.3mm total). If this seems to tight for you, you should have some wiggle room to scale the z-axis of the frame down to make it skinnier and still have the photo fit into the frame.

Also included are a few little figures you can attach to your frame to stylize it a little more. Just use glue!

Printing instructions

No supports!

Each model should already be oriented the way it was designed to be printed.

Use glue to secure the frame into its corresponding stand and to secure each figure to the frame as desired.

I find it fun to add a PAUSE command in the slicer to change the filament color for the figures.

More info

The frame was designed in a way to make it easy for people to design solutions to hang it on a wall or implement magnets to secure it to a fridge, so feel free to go to town!

Let your imagination go wild as you think up new and fun decorations to attach to the frame to make it yours.

Feel free to join my discord for additional support, questions, or suggestions!