Roller shutter box (fully printable and customizable add-ons)

-A box to quickly hide and access your stuff.

You might need to glue the roller handle to the end section.

Inspired by: roller shutter and shelves von Paul | Kostenloses STL-Modell herunterladen | Printables.com
 

Dimensions:
-hight: 197mm
-width: 210mm without add-on connectors (add-on connectors add 3mm in width)
-depth: 220mm

Parts needed:

-1 handle
-21 shutters middle
-1 shutter end
-1 shutter beginning
-2 pins for each box (I designed them with a little hole in the top so you can pull them out with tweezers)
-(1 connector)

Print Guide:

-Printed everything in PLA
-everything with 0,2mm
-everything with 15% gyroid infill
-activate brim for shutters and handle (make sure to also remove it properly on the inside)
-no skirt

Supports:
-No supports on the Rollers
-use paint-on support→ smart fill
-use clipping view to get in the spots you can not reach
 

Paint-on support settings:

-every box needs supports for the rail overhang on both sides:

-paint-on supports like this on the upward printing roller handle:

Rotate parts as you want and how it suits best for you in the slicer. Rollers can be printed with the female connector to the ground and the male up:

Post it holder supports with paint-on supports:

Assembly:
→slide all rollers together so one side is completly flat when lying straight
→slide the rollers in the box from behind with the three holes and the flat side pointing up
→add the handle to the bottom roller
→stick the pins in the two holes on the top of the box
→optional: silde the connector in

Finished :)

Add-on dimensions: