Print-in-Place Box and Stand for Wolfcraft Countersink

Box for Wolfcraft countersinks that protects them and acts as a display stand. Also very satisfying fidget toy. Print-in-Place verison

The lid is kept shut indirectly by magnets. Countersinks can be displayed at 90° and 45° for easy access.

Optional magnets in the back allow for mounting on vertical magentix surfaces

Size: 52 x 52 x 19 mm

designed to fit Wolfcraft countersink
2546000
2547000
2548000

If you want to use it for similar ¼'' Bits, dimensions of the biggest fitting countersink are pictured. The tip of the countersink holds the lid closed, so lenght has to be close to 35mm. Diameter should not exceed 13mm.

Printsettings:

print on top surface
4 perimeters
no supports

Hardware:

2x magnet D5 x 2
2x magnet D5 x 5 
Superglue

(Optional)
2x magnet D12 x 2

Assambly:

1. Remove Support
2. Glue 2 Magnets D5x5 into side of countersink holder
3. Turn countersink holder so magnets face bottom.
4. Reverse Box
5. Glue 2 Magnets D5x2 into small holes on bottom such they are attracted to the Magnets in countersink holder
6. (Optional) Glue 2 Magnets D12x2 into big holes on bottom

Notes:

.step-files are provided in case you want to adapt to other Bits. If you do, feel free to add a remix.

optimized for Print-in-Place