This is an attachment for the Makita trim router for edge band trimming. It is designed to use with a 0.5" bit. The mounting plate allows for micro-adjustments to allow for a perfect trim. I use a bullnose router bit to avoid an edge caused by the straight bit.
For safety, the router bit is completely covered. There is a small opening that allows the shaving to escape.
To install, replace the router soleplate using the same screws.
If the amount of trimming is significant then I suggest you lift the motor end slightly and take several light passes before you do a final 'flush' pass.
This tool requires two hands to operate safely, therefore the routing object needs to be fastened down.
Please like and post a make!
Printer Brand: Prusa
Printer: I3 MK3S
Rafts: No
Supports: No
Resolution: 0.2
Infill: 20%
Filament: Filament One ASA gray
Notes: this needs to be strong so use at least 5 layers. I chose ASA filament because of its strength. PETG could be used.
No supports are needed, print at presented.
Fusion 360
Category: Parts
The author marked this model as their own original creation. Imported from Thingiverse.