Stand for the included Prusa dual spool holder.

It is designed for use with an enclosure where you feed your filament from above. This is the first version and there are some things to improve,.but it's already practical. I printed it at 0.2mm speed settings with organic supports on my MK3s+ in under 3 hours.

Recommended printing parameters:

• PLA, PETG, ABS, but because of the long legs you may get lifting w/o a brim or heated enclosure
• Tree supports
• 0.2mm SPEED
• Higher infill around the bracket is recommended

Once printed, you should SLIDE the spool holder onto the printed holder, NOT SNAP. It's a snug fit; trying to snap it on will be a PITA. Future iterations will probably address this better.