D Ring - Gated

Suggested print settings for PLA:

• Layer height 0.2mm.
• Infill 80-100%.
• Perimeters: 5 (for strength).
• No supports needed.
• Optional: Enable Ironing (for better surface results)
  • Flow Rate: 15% (default).
  • Spacing between ironing passes: 0.1mm (default).
  • Ironing Type: All top surfaces (default).

Suggested print settings for PETG:

• Layer height 0.2mm.
• Infill 80-100%.
• Perimeters: 5 (for strength).
• Brim Width: 3mm.
• Brim Separation Gap: 0.45mm.
• No supports needed.
• Optional: Enable Ironing (for better surface results)
  • Flow Rate: 15% (default).
  • Spacing between ironing passes: 0.1mm (default).
  • Ironing Type: All top surfaces (default).

Explore other backpack accessories HERE.

NOTE
Most of our designs are printed and tested on a Prusa Mini and MK4, so tolerances may vary if you are using a different brand. While we strive for a smooth experience with our designs, we appreciate your understanding if tolerance issues arise.