SK1 - Webcam K1

2 Different Mounts for the Creality K1 Cam to be mounted to the SK1

One is mounted to the right Top-Z Mount. The other is mounted to a M3 through hole in the front right corner.

The FOV picture with the toolhead in the middle is from the Z-Mount. The one without is from the through hole mount.

For the through hole mount you need to remove the little metal cableguide. The screw can be used for the cam-mount.

Parts:

• Creality K1 Cam
• USB to PH1.25mm 5pin
• 1x M3x10 Countersink
• 1x M3x10 Flathead
• 1x M3x12 Flathead
• 2 little Zipties

Both flathead screws are only needed for the Top-Z mount.

The Zipties are used for the throughhole mount, to mount the cableguide to the idler standoff, since we've removed the original one.

The countersink screw is screwd directly in the mount from the inside of the backplate. If you want to prevent the rotating of the backplate relatively to the mount you can put a piece of 1.75mm filament through the backplate in the mount. But in all honesty, this is just a “legacy” feature since you can really tighten the screw to the point of no movement without a considered amount of force.

Don't worry about my cable placement, it was temporary to test the viability of the K1 cam by canibalize it from my K1.