Whale shaped busy board / fidget board

This is a fun little busy board with about as many things to keep a toddler occupied as can fit on a build plate.

Print Instructions

All parts can be printed with a 0.2mm layer height, 15% infill, and snug supports are only required for the rings and ring bars. A brim is recommended, especially for the large whale.

Assembly Instructions

There are indentations on the large whale for where each of the parts go, but just follow the pictures for reference. 

The parts need to be glued into place, just remember to put the rings on the ring bar and to attach the small whale to the slider before glueing them to the main board! 

There are pins to connect the moving parts, so just slot the pins into place and glue them (the pin files are named so that you know which pin goes with which part). 

Super glue worked just fine for me ;-)