Voron Galileo 2 Extruder - PG11 Cable Gland Motor Adapter

Sometimes you need a larger cable gland than the PG7/M12 version everyone uses. If your using a premade CAN cable and do not want to repin or cut your cable then this is for you. PG11 is just slightly too small for the LDO Nitehawk Cable. Drill it out and then pass the molex connector through the gland. PG12 or larger might be a better option.

Hardware : 

• 4x M3 heatset inserts for standoffs.  
• 2x M3 screws, Button head or socket, 6-12mm long. 
• 1x 4" zip tie
• 1x PG11 Cable gland

Use longer screws if you have to when installing the motor to the Galileo 2. Then Screw the standoffs to the motor. The plate attaches to the other end of the standoff. 
 

Edit 2024-03-18 : Added the PG 11 Motor mount. This could probably use more refinement.