Monstera Leaf Snowboard Stomp Pad

Similar to our all of our stomp pads! 

This was part of a custom order from Manuela from Etsy, thanks for the great idea! 

This model uses the same tried and tested (and very sharp!) pyramids to bite into your boots and provide unparalleled stability while skating. 

Don‘t have a printer? Check out my Etsy Shop or buy it from me directly! 

Features: 

• Large, approx. 5"x5" foot surface
• Sharp, densely packed pyramids to grip into your boots 
• Cut out holes and leaves stand out in the snow! 

Tips: 

• Print in PETG, ABS, or even PLA! I sell the pad printed in PETG but my PLA “tests” still hold up day after day. 
• Use a strong, 3M VHB weather resistant tape. I cover the entire paw and it's incredibly strong and cold/water/snow resistant. I use 3M VHB 4905 sourced from Amazon. 
• Clean your board (or at least where you want to apply the pad) and apply at room temperature for the best bond. Wait at least 24hrs if possible before going out. 
• The pad is SHARP. This is by design and it helps to really grip into your boot. Be careful when applying