LACK Table Filament Spool Holder

A different spool holder to attach to the top of the LACK Table Enclosure.
1
23
0
129
updated February 20, 2024

Description

PDF

The spool holder included in the LACK table enclosure parts was not working for me at all.  My spools kept jumping off the rollers and causing a jam.  So I created this alternative.  It does make a little bit of noise.  It works well, but could use some fine tuning.  You may see a Mark 3 show up here when I get around to it.  It's functional, it just makes some noise.

If the print head is parked more then a few inches above the bed from the last print, I yank down some filament through the hole into the enclosure.  The print head sometimes thinks it's jammed if it tries to dispense filament by pulling on it with the z-drive.  I have had zero problems with the extruder pulling on the filament.  So once a print gets underway, this spool holder has been flawless for me.

 

Tags



Model origin

The author marked this model as their own original creation.

License


Highlighted models from creator

View more