No Support 50A Anderson Plug Protective Cap

A remix of a design by @trevor229 to allow the cap to be printed without supports.
6
59
0
200
updated February 20, 2024

Description

PDF

A remix of a 50A Anderson Plug cap that requires no support and has a hole for a tether to allow it to be attached to the Anderson plug when not in use. 

I did not need glue to get the pins to stay in the cap body, but depending on the tolerance of the printer your experience may vary.

Model origin

The author remixed this model.

Differences of the remix compared to the original

A remix of a design by @trevor229 to allow the cap to be printed without supports. The body of the cap and the protruding pins are printed separately with the pins laying flat on the bed and the cap standing upright. Once printed, the pins are pressed into the body of the cap. I also removed the lanyard hole and replaced it with a tapered 5.5mm hole through the body of the cap, which requires no support and means the cap can be printed flat on the bed. The overall length of the cap was also extended to provide a way to grip and remove the cap.

License