Toyota GR Supra MKV Magsafe Phone Mount

This is a simple Magsafe phone mount for the MKV Supra. There are two models available: 

1. Flat
2. Angled

The mount clips into the grooves on the dash as shown in the installation video below.

You will need to buy a ring magnet to attach to the mount. If you don't have a Magsafe phone/case already, you'll need a ring magnet for your phone also. The ones I linked are cheap and arrived relatively fast for me. I did add a bit of superglue to the mount before placing the adhesive side of the ring magnet in place just in case it wasn't strong enough to hold the magnet in place.

I did notice when mounting it in different spots that the dash is not perfectly consistent and some spots are a little tighter than others. I made it so that it can still fit in the tight spots with a little extra squeezing but still be secure in the looser spots. Not sure if different cars will be much different but I'm assuming it should be pretty close.

Print Settings:

Print face down. I used a faux carbon fiber build plate to get the design on the face.

Material: I used ABS. PLA won't stand up to the heat it'll be subjected to in the car. ASA is probably ideal and PETG would probably work well also. 

Layer Height: 0.2mm

Walls: 4

Supports: None

Infill: 15% (gyroid)

Brim: I needed one to prevent corner curling with ABS but your mileage may vary depending on material.

Feedback and requests are always welcome!