LED Light Bar Prusa MK3

I printed everything from PLA and I printed the diffuser from clear PLA

The parts of the light itself, which are long, I also glued in one piece. These parts need to be turned for printing by 40 degrees so that they can be placed diagonally and then it is not a problem for printing

To assemble, you will need approx 50cm of two-wire wire, 60cm of some led strip, and a switch size of 10x15mm

you can also use electronic parts from the original model for MK4

more information about the construction and other things is with the original model:

LED Light Bar Prusa MK4 od autora In3DSpace | Stáhněte si zdarma STL model | Printables.com

for example switch: Vypínač kolébkový SMRS-101-1, OFF-ON 1pol.250V/1A : H A D E X , spol. s r.o.

Original is for prusa mk4, so I make it and it is for prusa mk3