Sea Star Bath Toy

Cute little sea star toy for the bathtub. The eyes are movable and print-in-place. Mouth can spout a little bit of water when blowing through a hole at the back.

Printing Tips

• Should be an easy print. The only challenge could be the print-in-place eyes. Make sure bed is clean so the eyes don't dislodge while printing.
• I used PrusaSlicer Structural default settings. Slower is better for the eyes to come out smooth.
• No need for multicolor 3D printer, just use an alcohol based maker pen to fill in the eye pupils, easy.

Changed shape into sea star and whistle into water spout. Eyes are the same, only slightly bigger for easier printing.