Ender 5 C920 Camera Mount

This hard mount replaces the C920 monitor mount. It has two bolt holes for easy attachment to 20x20 extrusion.

It requires disassembly of the camera, but it is not that complicated, and it's reversible! Guides can be found on YouTube (stop at 6:18).

There are 4 versions.

The Alt Tall version places the camera outside the perimeter of the machine and higher up for more clearance and the widest view. This is the version I use.

The Alt version places the camera outside the perimeter of the machine for more clearance and an even wider view. This version was used to take the included screenshot.

The Vertical version places the camera immediately above the perimeter extrusion of the machine for more clearance and wider view.

The original version places the camera inside the perimeter of the machine for a closer view.

Mounts to an extrusion rather than the Prusia i3.

Re-uses the camera interface of this original file.