Waveshare 3.5" mount for Voron V0.2

A display mount for the Waveshare 3.5" Capacitive Touch Display for a Voron V0.2 printer.
5
25
0
350
updated February 14, 2024

Description

PDF

A mount for the Waveshare 3.5" IPS Capacitive Touch LCD Display, 480x800 for the Voron V0.2 printer. Note that there are other 3.5" screens – this mount is for a very specific one, SKU 24037.

The screen uses HDMI connection for the video and USB-C connection for the touch signals. 

Since I wanted to hide the connectors, and on this screen they stick to the side, I went with specialized cables used in FPV drones (I suppose?). They are smaller than the standard HDMI / USB-C cables. See BOM for the details and the photo.

The mount goes in between the front two skirts, similar to the stock mount. Note that the side skirts need to be trimmed as I haven't redesigned them yet. 

I use this screen with the BigTreetech Pi V1.2 board. I am not familiar with the Raspberry Pi ecosystem, but it should work with other boards that have HDMI connectors (BTT Pi V1.2 uses Micro HDMI, don't know about other Pi boards).
 

BOM

  • 4x M2.5x6mm screws (for mounting the display)
  • 4x M2x6mm self-tapping screws (for mounting the cover)
  • 2x M3x6 screws to mount to the frame
  • CYFPV 20 Pin FPC Ribbon Cable (cablecc CY CYFPVHDMI 50cm HDTV FPC Ribbon Flat Cable Pitch 20pin for HDMI 1080P HDTV FPV Multicopter Aerial Photography)
  • CYFPV HDMI Type A (cablecc CYFPV HDMI Type A Male Connector Up Angled 90 Degree for FPV HDTV Multicopter Aerial Photography)
  • CYFPV Micro-HDMI Type D (cablecc CYFPV Micro HDMI Type D Connector Angled up to 90 Degrees for FPV HDTV Multicopter Aerial Photography)
  • CYFPV USB-C to USB-A cable (cablecc 0.5M Up Down Angled USB 2.0 Type-A Male to USB-C Type-C Male Data Flat Slim FPC Cable for FPV & Disk & Phone)
     

Tags



Model origin

The author marked this model as their own original creation.

License


Highlighted models from creator

View more