Speed Pad holder for V400

Motivaton:

• I need a speedpad mount that stays display inside boundary of V400 (to avoid hit the pad if it is outside pillar)
• The models that snaps into gaps dont work for me. Dont fit exactly or falls over... I find it too dangerous
• So, I grabbed Venons project to use as a base and remodeled from scratch, mantaining 10º inclination in front, removing middle part and keeping almost flat from V400 facade.

Hardware needed:

• Justs 2 nuts and 2 bolts M4 (12-20mm is fine)
• Check video assembly here: 

Design:

• I tried to keep usage of filament low, under 50gr, and a simple design, using chanfer instead of curves to print without support.
• Be gentil manipulating it. Because of offset in center of gravity not sturdy as center supported axis

Print settings:

• Print one support and two track insiders. Remember to rotate in slicer software to flat in the table like the pictures attached.
• No supports are needed, I design everything under 45º
• I printed in PLA with infill 30% in support and 50% in insiders. But a stronger material, like ABS, PETG probably is better.

Future plans:

Im planning doing a version that has a hinge to open like a door. But, for me, its working nice so far. Or, maybe, a sturdy version with more filament usage.

Cheers from Brazil

I used venom´s model as a base for dimensions, but remodeled from scratch