Fitbit Sense Charging Stand

The magnetic pins on the charger was starting to annoy me, if you didn't align it just right it wouldn't actually charge, grrrr

To combat that, I mocked this up so you have to place the Fitbit on the stand and it's already aligned and will magnetically connect, magic

Details

• Height - 40mm
• Width - 30mm
• Depth - 35mm
• Compatibility
  • Any Fitbit Sense (and maybe SenseCompatibility 2 if it uses the same charger as you see in the pictures)
• Print settings
  • PLA
  • Orange (defo can't lose it)
  • 0.28mm res, was meant to be a rough print test but turned out pretty well
  • Print on its side, so supports required (can see in slice photo)
    • Unless your printer can print magic and you can do upright
    • The overhang as I designed the top transition badly; it's not smooth :(
• To fit the charger in the stand, put the thinnest part of the cable in, then push the slightly thicker part of the cable (right by the actual charger) into the gap and smush it in; that compression fit will keep it in place, no need for glue!