RunCam2 Case
Description
PDFPrintable replacement for the RunCam2 case.
I went through many iterations tuning the snap fit geometry to both hold the camera well, yet also allow it to release relatively easily. I decided to leave out the thumb tab release as I found it to be awkward and difficult to access, just push the camera out firmly and it will release.
Also included is a GoPro mount adapter that snaps into the case. This allows you to mount the RunCam2 to any GoPro compatible mount/accessory.
The case prints well in PETG, 100% infill, no supports. It would probably work ok in PLA but the release might be a bit stiff.
The GoPro mount was a remix of https://www.thingiverse.com/thing:2092007
Model origin
The author remixed this model.
Differences of the remix compared to the original
Low profile version of the GoPro mount for RunCam2.
