Snap-on 14.4 Impact/Screw Gun holder

Holds Snap-on 14.4 Impact and Screw Gun

Printed with 15% infill and used PETG for the one shown. The total print time on a Bambu was around 90 minutes, Ultimaker shows around 4.5-5.5 hours on an Ender 3 v3 SE with the same infill setting. You will need support and I recommend printing it upside down to minimize material use

I've been using it for about a week and it has worked amazingly well to help open up some room in my tool cart. 

You are more than welcome to modify and tweak it as you see fit to suit your needs. Would appreciate credit if upload a modified version.