Drip tray for large coffee urn or other beverage dispenser

The space we use for a community meeting put in new flooring and we wanted to keep coffee drips off the floor.  I designed this after trying to find drip trays to purchase, I found them overly expensive.  This is the fifth iteration, I didn't feel the others were worth uploading.

This prints in 3 parts to allow it to bring w/o supports, however the connector may need supports on your printer to keep the threads from drooping.  The cone in the bottom is to discourage people from using it as a cup holder.

The 3 parts also allow better tolerance when lining up the top and bottom pieces, as the connector is shorter than the the two female threads in the top and bottom.  It also allows for only having to reprint one part if one breaks.  If you look at the last picture you can also turn the top 180 degrees for easier storage.

I printed this on a Creality Ender S1 with a Sonic Pad using Overture PLA Plus.  I find the PLA Plus filament resists shattering when dropped better than either PLA or PETG.