SPEyewear 2

An elegant pair of glasses. The frame is ready to accept 6base curve lenses.

Print instructions

Category: Glasses Print Settings

Printer Brand: Prusa

Printer: Prusa Mk2

Supports: Yes

Resolution: 0.1

Notes:

For the best printing result it is advised to use PVA for support material. Otherwise, it is important to use the suggested settings below.
For the temples you do not have to use brim; the two small pads help to bed adhesion.

Cura Settings
Layer Hight : 0.1mm ( or 0.06mm)
Support : Yes
Support Density : 20%
Support Z Distance : 0.2mm
Support Horizontal Expansion : 0.5mm
Enable Support Interface : Yes
Support Interface Thickness : 0.4mm
Support Interface Density : 100%
Brim : 1mm (for the frame, if you have adhesion problems)