CPAP Holder with strap holes and command hook plates

I wanted a combination of improvements for the CPAP holder by JayceFyrestorm over on Thingiverse, and so I basically combined the improvement ideas from servel333 and added plates for the hook to be mounted with command strips, as well as Debay777 and added holes to thread velcro to hold the hose in place. I also made sure that the screw holes were still able to be used just in case. Uses 2 medium size command strips if used.

Print Settings

Printer Brand:

Creality

Printer: 

Ender-3 V3 KE

Rafts:

Doesn't Matter

Supports: 

No

Resolution:

0.20

Infill: 

50%

Filament: Sunlu PLA White, but literally doesn't matter

Notes:

Printed at 50% infill with Cubic. Wanted a little extra strength than the standard 20%, but honestly, 20% is probably fine. Also I printed with and without supports and they’re almost exactly the same, but YMMV. It uses the medium size command strips

Category: Organization

I combined the improvements from the two remixes of the original: I added command strip plates and added velcro strap holes to hold the tubing in place.