Cue Grip Table Clamp holds 7 Cues. This was designed to grab the cue and hold onto it since iv seen too many expensive pool cues hit the floor after a little bump or table shake when the typical cue claws were used. rather than resting in a groove this model will hold onto the cue even if the cue is tilted away from the clamp. I added cut outs to the Body and Clamp to hold quarters, chalk, or whatever you don't want rolling off the table.
I designed the Strip to be printed with TPU (A95) and to be glued onto the body after printing.
The rest of the files can be printed with any ridged material you prefer PLA/PETG.
Screw was a little stiff first time using it however i recommend using a little WD-40 or just breaking it in a little and it will smooth itself out.
lastly, putting this whole thing in a case was an after thought so i will be uploading a v2 that should be easier to carry in a cue case.
The author marked this model as their own original creation.