Omnifixo Pinecil Case Plus

I love the case PosterBored made, but when I went to use it for the first time I realized I really needed a brass sponge, and would like an extra tip available on the go. I also wanted a larger hole to put my solder roll in. So I've added all those things to the model. All you'll need to complete the case is 2 10mm diameter x 15mm long magnets (or stacks of shorter magnets as I've used).Superglue them in and wait for it to dry and you're all set.
I printed mine in PLA, with a .6mm nozzle, .3mm layer height, 15% infill, 3 perimeters and 5 top/bottom layers. I'm sure pretty much any other settings or materials will work just fine.

The whole case has been enlarged. The hole for the solder roll is deeper. The holes for the clamps are also deeper and can hold two clamps each, but two of them have been replaced with a large rectangular hole for a brass sponge, or really whatever you want/need. There is now storage for an extra tip underneath the pinecil. The holes for the magnets are enlarged to 10mm diameter x 15mm deep.