New junction box with 4 inputs. The old models had only three and two openings. Two openings are located on one side (see the pictures).
This new designed 8 by 8 by 5 cm junction box (for antenna and speaker cables) features four inputs and can be securely attached to a surface using up to four screws.
Seals for all cable entries and holes for securing screws can be provided with printed seals.
A printable gasket is inserted between the cover and the housing. All seals were 3D printed in TPU and are flexible (red parts).
The housing and cover were printed in PETG. The cover is fastened with 4 screws (4 mm).
The print was done without support material. The models were created using Fusion 360.
Remarks:
I have also designed a:
If you print or use this model please observe the relevant regulations in your country. Illustrative model (not for power cables). Use at your own risk
The author marked this model as their own original creation.