Guitar Stand Pro X 2000

After 40,000 years of research, here is the Guitar Stand Pro X 2000 - outperforms every normal guitar stand by 50%. Our top scientists have finally found it, and everyone wants this. The price for the models would be $95,000, but now you can get it for free as a special offer

You need 4 pieces of M3 x (minimum) 24mm METAL screws for assembly, two from each side to secure it to the stand - these definitely require nuts as well - and two from the top to clamp the accessories with METAL screws so that the small holders don't sway even when the stand is tilted at a larger angle.

There are 5 types of accessories:

1., For headphone amplifiers, where we use a 6.3mm jack (not too tight to avoid damage). (In my picture, there is a Nux Mighty Plug Pro)

2., For headphones with a 35mm width with a small cable holder section.

3., For headphones with a 35mm width without a cable holder section - this has a slightly higher rim so that if you want to hang a guitar cable here instead of headphones, it will be tall enough.

4., For headphones with a 40mm width without a cable holder section.

5., For headphones with a 45mm width without a cable holder section.

I have attached a picture with what I believe are the most important dimensions.

Every small accessory is rotatable so that you don't have to play sad music because you scratched your guitar with the metal part of the headphone or with a cable that might be made of METAL

- I used prusament PetG with 15% infill (You can use higher, but it's stable for me)
- 0.2mm
-On the base part: enabled Support