Proxmark3 RDV mounting board

This board allows for secure mounting of your Proxmark3 RDV and its two coils.

Print this model using 0.2mm layer height - this will allow for hole supports to be correctly self-supported by a single layer bridge, that you will need to remove during assembly.

Additionally you will need to have:

• 2pcs of 15 cm MMCX rigtht angle pigtails (rigtht angle connector both sides).
• 8pcs of M2 standoffs (10 mm height)
• 16 pcs of M2 nuts
• 8pcs of M2 screws

Enjoy!