Undead Rogue

This filament painting was created while testing the limits of the depth on a design.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA Overture Black
• PLA Overture Cement Gray
• PLA+ Sunlu Gray
• PLA BambuLab Basic Gray
• PLA+ Esun Bone White
• PLA Overture White

Swap Instructions:

Start with Black

• At layer #14 (1.2mm) swap to Cement Gray
• At layer #16 (1.36mm) swap to Sunlu Gray
• At layer #20 (1.68mm) swap to BambuLab Gray
• At layer #26 (2.16mm) swap to Bone White
• At layer #35 (2.88mm) swap to White for the rest.