Stand for GameSir X2 (or other handheld)

The stand consists of two holders and a connector. Using the connector is optional, it only keeps the two holders in position. If you use it, make sure to tilt it slightly so you don't see it through the hexagonal hole of the holder, then use some super glue.

This setup also fits other handhelds - like the PowKiddy X55.

Print the holders twice. The tabs on the connector indicate their width when a Samsung Galaxy S9 (or similar) is inserted.

I printed the holders oriented on their sides. Also for the connector, the Cura plugin “TabAntiWarping” can provide small circles that help with the bed ahesion. With these, all the prints came out perfectly the at the first time.

I used a 0.6mm nozzle and 0.28mm layer height.