Gagguino Front Mount Angled Screen GCP (No Solder)

Mount your Gaggiuino screen in style with this single piece print.
13
144
0
861
updated May 22, 2024

Description

PDF

Hello! Welcome!

I've redesigned the mount so hopefully it is easier to use and doesn't require the extra soldering the original needed to move the connector. It is designed so that the screen can be plugged in and then slotted into the print. Once it is in place, two M3x5mm screws are used in the top mounting holes and thread directly into the printed part. There is enough clearance on this version that the indicator lenses don't need to be removed.

Model origin

The author remixed this model.

Differences of the remix compared to the original

These are the updates:

  • Created clearance for the harness to be plugged in before install
  • Increased the chamfer at the back of the mount to accommodate the clearance
  • Only two screws to be directly threaded into the screen for mounting
  • Increased height of switch cutout to 30.5mm to match switch spec sheet (mentioned by @nate52897 on discord)
  • Extended screen downward 5mm for SD card tray issue (mentioned by @chrisbarratt_1671653)
  • Thickened area near bottom of switches for more robust part

V0.2

  • Updated model for clearance for connector

V0.3

  • Moved rib clearance for EF2319 chip, some screens not able to slot in fully

V0.4

  • Added 2mm clearance behind board and 0.7mm under screen

V0.5

  • Screen is right side up, no need to flip .tft files anymore. Added SD card slot access to the bottom.

License